Is it difficult to assemble DC brushless motors? What are the details to pay attention to?

DC brushless motor assembly is not difficult? Many friends are curious about how the motor is assembled and what are the important details, Vacuz gives you an introduction! Hope it can help everyone!

DC brushless motor stator winding is completed, the need for manual pin winding, needle winding need to pay attention to the following points.

1, install the pin hole on the stator of the DC brushless motor and insert the pin into the designated position.

2, wind the coil leads on the pins according to certain requirements, and cut off the excess wire with sharp-nosed pliers.

If we want the brushless DC motor equipment coils normally energized, we need to remove the insulation varnish at the end of the enameled wire, paint removal process.

1, pour the appropriate amount of paint stripper into the paint stripping tank.

2. put the finished stator winding into the paint stripping tank and soak it for about 2 minutes.

3. use a brush to peel off the peeling paint.

Brushless DC motor equipment needs to record the energized wire slot according to the Hall induction switch, so as to control the rotation of the motor through the driver, the signal acquisition requires the use of circuit boards, welding circuit boards need to pay attention to.

1. soldering the Hall switch to the circuit board.

2. cutting off the excess Boolean switch pins.

3. soldering the circuit board to the corresponding pins.

4. checking the soldering of the circuit board and pins.

5. After correction, put the stator into the housing and finish the stator according to the process.

These are the details of DC brushless motor installation, mastering this knowledge will help to understand the structure and composition of the motor, and pay attention to these issues in actual production.

WhatsApp/Wechat: +86 13075286997

E-Mail: sales@vacuz.com [fusion_form form_post_id="431″ margin_top="" margin_right="" margin_bottom="" margin_left="" hide_on_mobile="small-visibility,medium-visibility,large-visibility" class="" id=""][/fusion_form]