Winding machine manufacturers: the height of the winded object and the lineup

Winding machine manufacturers: the height of the winded object and the lineup machine! Vacuz machinery and equipment to give you a science!

The winding technique of the winding machine is very important. First of all, the “line” characteristics, the number of loops and the appearance of the material, the speed of lifting should be like sticky silk, colored cotton thread, etc., and a group of diameter line should increase a lot, because the skin is not smooth, no inertia characteristics. Filament winding speed should not be too slow, but should start with a slow climb so as not to break the filament. The speed of thick wire should not be too fast (over speed), but pay attention to whether the low and medium speed torque is sufficient.

Automatic wire winding machine manufacturers talk about the use of aluminum wire, please note that the tension should be adjusted to much smaller than the same thickness of copper wire, so as not to draw too large a diameter, the outer insulation coating burst, affecting product quality. When using aluminum wire, the wire diameter should be increased appropriately due to the reduced expansion force. The combination of its own strength requires the ability to go less and move more. The shape of the winding object of the transformer winding machine depends largely on the height of the setting machine and the distance off the machine. The speed of the square winding object should not be too fast, the middle will be round and convex, affecting the neatness of the line.

The height of the object to be wound and the wire should be appropriate, too low the wire will easily fall into the next layer, too high will have the phenomenon of jumping wire. The distance between the wire and the object to be wound should not be too far, it will affect the accuracy of the wire coupling. The tension of the layout device is also related to the beauty of the winding arrangement. The width of the winding material and the calibration of the starting point are of paramount importance. When the starting point is correct, the winding is started and can be stopped at both ends to test if the width setting is correct.

When starting the winding, the starting winding point is too forward or too backward (no vertical phenomenon between the outlet and the wire object to be wound), whether aesthetically pleasing or not. Too thin or too dense (incorrect wire diameter setting) The ends are rotated too fast or too slow (incorrect width setting: too fast = not enough width, too slow = too wide) Whether the connection becomes faster and slower (fine-tune the wire diameter again: faster = smaller, slower = bigger)

Note the coupling of several layers of wire behind the winding. The shape of the object changes through multiple layers of entanglement. The wire diameter marked on the enameled wire is the actual wire diameter, so the wire diameter must match the thickness of the enamel. The resetting (displacement) of the wire liner after the winding is completed is also important. Fine winding, start winding point forward, wide to narrow a little. Jumper winding, which can generally overcome the setting pattern.

WhatsApp/Wechat: +86 13075286997

E-Mail: sales@vacuz.com [fusion_form form_post_id="431″ margin_top="" margin_right="" margin_bottom="" margin_left="" hide_on_mobile="small-visibility,medium-visibility,large-visibility" class="" id=""][/fusion_form]