Servo motor stator and rotor press-fitting process is also very important, the use of manual press-fitting, a little inattention, it is easy to damage the shaft, but also may lead to bad concentricity, but also easy to press to the hand, resulting in safety problems, then how to press-fit the servo motor stator and rotor? What details need to pay attention to? The following Vacuz simple to give you an introduction to it! I hope it can help you!

Servo motor stator and rotor press-fitting process, usually includes the following steps and details that need attention:

First, stator press fitting

1. Select the appropriate press-fitting method: according to the size and structure of the motor, you can choose to weld or mechanical fixing method of stator press-fitting. Mechanical fixing methods generally include cold pressing and hot pressing methods.

2. Clean the working area: Before starting the press assembly, make sure the working area is clean and tidy, remove all debris and dust to avoid dust and impurities from entering the motor.

3. Use the right tool: Choose the right tool for press fitting and make sure the quality and precision of the tool meets the requirements. For example, for cold pressing method, special fixing tools and jigs need to be prepared.

4. Position the stator: Place the stator in the correct position within the motor housing and fix it using a positioner. Ensure that the stator is correctly positioned and aligned with the motor housing interface.

5. Press-fit stator: Clamp the stator to the motor casing with a pincer-type clamp to ensure that the stator is securely fastened in the motor casing. During press-fitting, pay attention to the strength of the clamp to be moderate, so as not to damage the stator or motor shell.

Second, press into the rotor

1. Prepare tools: Prepare tools such as rubber hammer, pressure clamps, and pressure unloading molds.

2. Clamp the rotor shaft: use the clamp to clamp the rotor shaft of the motor to ensure that the rotor shaft remains stable in the press-fitting process.

3. Disassemble the old bearing: If the old bearing is already installed on the rotor shaft, it needs to be disassembled by using the disassembly jig.

4. Press-fit the new bearing: Use a press-fit mold to press-fit the new bearing onto the rotor shaft. During the press-fit process, ensure that the bearing and rotor shaft are properly aligned to avoid excessive forces that could damage the bearing or rotor shaft.

5. Evenly press-fit the bearing: Carefully tap the motor rotor with a rubber mallet to evenly press-fit the bearing. Be careful to use moderate force to avoid damage to the bearings or rotor shaft.

III. Precautions for press-fitting
1. Read assembly instructions carefully: Before starting assembly, read the requirements and steps in the assembly instructions carefully and follow them.

2. Use proper tools: Use proper tools during press-fitting to avoid damage to motor parts due to the use of improper tools.

3. Keep clean: Ensure that the working area and all parts of the motor are clean to prevent dust and impurities from entering the motor and affecting its performance and life.

4. Attention: In the process of press-fitting, pay attention to the control of force to avoid excessive force and damage to the motor parts.

5. Check the quality of press-fit: After the press-fit is completed, the quality of press-fit must be checked to ensure that the stator and rotor are firmly installed and in the correct position. If any problem is found, it should be adjusted and repaired in time.

How to press-fit the servo motor stator and rotor? What details need to pay attention to? Vacuz above has done a detailed explanation, I hope these tips can help you!

Sähköposti: sales@vacuz.com