Stepper motor speed is not enough to do? How to increase the speed of stepper motor

How to control the speed of the stepper motor? Speed is not enough to do? Many friends have questions about the common control methods are not clear, the following Vacuz briefly introduce you to it! Hope it can help everyone!

Control principle: the principle of controlling the speed of stepper motor, mainly through the control of pulse frequency is to achieve, master the drive subdivision value size.

Stepper motor why the speed is not enough?

1. In general, the actual speed is lower than the theoretical speed, a big reason is out of step, the load is too large.

2. Theoretical speed is slower, most likely caused by the low pulse frequency, you can properly enhance the pulse frequency.

Ways to improve the speed of stepper motor.

1, you can increase the pulse frequency, if the PLC pulse output control stepper motor, you can provide a higher speed according to the high-speed pulse output supported.

2, reduce the subdivision factor M to improve the speed of the method.

To clarify is that the pulse frequency can be increased, generally do not go to reduce the M value, and then the speed should not exceed 600RPM.

Stepper motor speed is not enough to do? How to improve the stepper motor speed? The above is a simple explanation, I hope you can initially understand the stepper motor.

왓츠앱/위챗: +86 13075286997

이메일: sales@vacuz.com [fusion_form form_post_id="431″ margin_top="" margin_right="" margin_bottom="" margin_left="" hide_on_mobile="작은 가시성,중간 가시성,큰 가시성" class="" id=""][/fusion_form]