The correct use and routine maintenance of the automatic transformer bobbin coil winding machine

To ensure the normal work of a winding machine, daily inspection and correct operation is an important indispensable step, first of all, should establish equipment manual for daily records and access to read the operation of the winding machine and the existence of problems, the beginning of the work to carefully check the table, line guide and the main sliding surface, such as obstacles, tools, impurities, etc., must be cleaned, wiped clean, oiled, carefully check Equipment moving mechanism has no new pull, research, touch injury, if there should be informed of the equipment together to see if the analysis is due to failure, and make a record, check the safety protection, power supply, limit devices should be complete and intact, check the electrical distribution box should be closed securely, good electrical grounding, check whether the equipment accessories are good. Over the line wheel, felt clip, wire release, ceramic parts, etc. should be complete and intact, installed correctly, idle operation test run to observe whether the smooth operation, there is no abnormal noise, etc..

Although the above work is tedious, but can effectively determine whether the equipment is in good condition and prevent the occurrence of failure.

After inspection, such as no abnormalities, then you can normally start the equipment for winding operations, in the operating process as the operator also need to strictly follow the rules of use, there are many inadvertent operations will be different degrees of damage to the equipment, in the use of the process, should be carefully operated, do not do things that have nothing to do with the work. When leaving the equipment for business to stop, turn off the power supply, air supply, should be wound according to the provisions of the process.

Not allowed to arbitrarily increase the wire diameter, number of turns and winding speed. Do not allow over specification, overload, overweight use of winding machine, winding axis, mold should be clamped correctly, do not allow the use of a longer handle to increase the torque of the method of fastening the mold, etc., the spindle and line mechanism of mechanical shifts, mold clamping, adjustment, etc. should be carried out after the stop, with a protective device is to ensure the safety of the operator after the abnormal condition of the equipment, do not allow unauthorized removal of the safety guards on the equipment, winding machine On the wire winding machine, especially the line wire rod and winding diameter is not allowed to directly place tools, workpieces and other debris, pay close attention to the operation, such as the discovery of action failure, vibration, heat, crawling, noise, odor, bruises and other abnormalities, should immediately stop to check, troubleshooting, before continuing to work.

After completing the work should be correct stop and clean, first of all, electrical, pneumatic and other operating switches on the non-working position, completely stop the operation of the equipment, cut off the power supply, gas source, clear the debris left in the process of winding on the equipment, etc., carefully line up the displacement mechanism, the discharge axis and other oil maintenance, carefully fill out the equipment manual records perfect.

왓츠앱/위챗: +86 13075286997

이메일: sales@vacuz.com [fusion_form form_post_id="431″ margin_top="" margin_right="" margin_bottom="" margin_left="" hide_on_mobile="작은 가시성,중간 가시성,큰 가시성" class="" id=""][/fusion_form]