For brushless motor, the stator shape is various, the outer diameter is large and small, especially the micro motor, some stator is less than 10mm, winding is relatively difficult, if the machine is not adjusted slightly, it is easy to cause injury, broken wire, resulting in the stator can not be used. So micro motor stator winding in the end is not difficult? Vacuz give you an introduction to it! Hope these tips can help you!

Micro Motor

In fact, micro motor stator winding, it is not as difficult as said, technology and method is the key, and a wealth of experience, as long as you master these, debugging accurate positioning, winding or quite simple.

1. Machine configuration, if the requirements for the line is higher, or more difficult diagonal slot products, ordinary configuration may not meet the requirements, you need to adjust the configuration, the requirements are higher, so that the winding will be more fine.

2. Outer winding miniature stator, mainly lies in the mold house, flying fork, stator rod, skeleton, guard plate between the distance control, positioning to be accurate, if the slot is very small, the speed is recommended to slow down a little.

3. Inside winding micro stator, relatively more difficult, more difficult if the slot is very small, the needle rod is not good to go in, it is easy to scrape the line, hit the needle, etc., winding speed can not be too fast, remember to test after winding.

4. tuning skills, whether it is the installation of the mold, positioning test, or slow winding, parameter settings, need a wealth of experience to complete, to ensure that the line is not hurt, broken, jumping, hitting the needle, etc.

BLDC-motorens statorspole

Micro motor stator winding is indeed difficult, but also depends on the specific product, as long as experienced, mastering good debugging methods, generally speaking, can still easily handle.

WhatsApp/Wechat: +86 13075286997

E-post: sales@vacuz.com