Daily maintenance – teach you how to regularly check the automatic winding machine

Pay attention to the automatic winding machine is a machine belonging to the automation equipment, it is inevitable that there will be a time when the fault, but than he has a problem and then repair, it is too late, so the daily view is indispensable, the following, to help you customize the view program to help you troubleshoot.

A, daily check

Daily protective repair should be carried out after eight operating hours. After the day’s work, turn off the computer and the machine’s power supply, the dust on the back of the machine with a vacuum cleaner to clean and use a white cloth to wipe clean the dust and dirt on the exterior of the equipment. If the environment is poor, maintenance operations should be carried out more frequently.

(ps: do not use organic solvent wipe test, that may damage the equipment exterior paint.)

Second, weekly check

Weekly protective maintenance should be carried out after every 40 operating hours, such as a poorer environment, the cycle should be shortened pneumatic smooth equipment. Note: The slicker and smooth oil used must be of good quality. Otherwise, it will add the surface conflict of the screw or guide, and then shorten the service life of the screw, affect the accurate positioning of the machine, etc. WARNING: Do not use phosphoric acid and oxidized hydrocarbon synthetics in the smooth equipment or factory air circuit. Check the equipment in the smooth equipment, if required, can participate in 100CKR smooth oil.

Third, monthly check

Monthly protective maintenance should be carried out every 200 operating hours, such as the environment is poor, the cycle should be shortened pneumatic smooth equipment. Through the observation hole to view the flow of pneumatic smooth oil away, the flow rate should be divided into five minutes 3-5 drops, you can smooth the top of the device groove screw rotated to the back of the funnel to adjust the flow rate, the beginning should be adjusted to 1/4-1/2 open, clockwise and counterclockwise screw needle will make the smooth oil flow rate increased / reduced.

Automatic winding machine defects classification is no more than: electrical, mechanical, transmission, pneumatic (assuming that there are) these kinds of, which is divided into strong and weak electrical part, and winding machine manufacturers in general in the planning, use and maintenance of its CNC system, there is thinking about the vulnerable, easy to defective parts to give alarm, alarm circuit operation, on the one hand, in the flash screen or operation panel to give sound, light and other alarm information, on the other hand Send out protective instructions. Make the system power off or suspend operation to ensure safety and prevent the expansion of defects.

WhatsApp/Wechat: +86 13075286997

Email: sales@vacuz.com [fusion_form form_post_id=”431″ margin_top=”” margin_right=”” margin_bottom=”” margin_left=”” hide_on_mobile=”small-visibility,medium-visibility,large-visibility” class=”” id=””][/fusion_form]