Automatic brushless motor stator winding machine speed setting requirements

Automatic brushless motor stator winding machine is a device that winds wire, including enameled copper, aluminum and iron wire, onto a specific product. When using the stator winding machine, some parameters need to be adjusted, such as adjusting the machine winding speed to meet the current product usage requirements.

What requirements should be noted when adjusting the speed of the automatic brushless motor stator winding machine? Today Vacuz will give you a detailed introduction.

1, for self-adhesive wire, enameled wire, etc., set the wire diameter to increase a lot, because the outer skin is not smooth and does not have inertia characteristics, so the starting point and winding point of each step should be determined first.

2, the winding speed of fine wire should not be too slow, but the beginning must climb slowly to avoid breaking the line, and then determine the width, the width of only the width of the winding, and only the width of the winding.

3, for thick wire, the speed should not be too fast (over speed), but must pay attention to the low and medium speed torque is sufficient, and set the number of turns and wire diameter.

4, set high speed, low speed, stop and slow speed car well, the speed can not be adjusted to 0, and determine the winding direction and line up. When using aluminum wire, please note that the tension should be adjusted to much smaller than the copper wire of the same thickness to avoid thinning of the wire diameter and shedding of the outer insulation paint, which will affect the product quality.

5. When using aluminum wire, the set wire diameter should be appropriately increased due to the reduction of tension. Set it reasonably with your own needs to ensure that the tension is appropriate and not loose or tight.

The above is the common speed setting method of automatic brushless motor stator winding machine, I hope it will be helpful to you.

WhatsApp/Wechat：+86 13075286997

電子郵件: sales@vacuz.com [fusion_form form_post_id=”431″ margin_top=”” margin_right=”” margin_bottom=”” margin_left=”” hide_on_mobile=”small-visibility,medium-visibility,large-visibility” class=”” id=””][/fusion_form]