How do we ensure the proper operation of the automatic winding machine?

How do we ensure the proper operation of the automatic winding machine? The following winding machine manufacturer’s editorial will tell you!

To ensure the proper operation of automatic winding machine, daily inspection and proper operation are important and indispensable steps. The first winding machine manufacturers, equipment manuals should be established for daily records and inspections. Read about the operation and problems of the automatic winding machine. When starting work, we must carefully inspect the table, cable conduit and all major sliding surfaces. If there are obstacles, tools, impurities, etc., they must be cleaned, wiped clean, oiled, and carefully inspected for new pulls or studies on the equipment moving mechanism. If there is any injury, if the equipment should be notified to see if the analysis is caused by a fault, and make a record, check that the safety protection, power supply, restrictions and other equipment should be complete, check that the distribution box should be closed and the electrical grounding is good. Check whether the accessories of the equipment are good. The rear wheel, felt clip, discharge frame, ceramic parts, etc. should be complete and correctly installed, and idle running test should be conducted to determine whether the operation is stable and whether there is abnormal noise. Although the above work is troublesome, it can effectively determine whether the equipment is in good condition and prevent malfunction.

If there is no abnormality after inspection, the equipment can be started normally for winding work. During operation, the operator also needs to strictly follow the rules of use. There are many unintentional operations that can damage the equipment to varying degrees. During use, care should be taken not to do anything unrelated to the work. When leaving the equipment, stop it and turn off the power and air source. It should be wound according to the process regulations. Do not increase the wire diameter, number of turns and winding speed at will. Do not allow the automatic winding machine to be used for over standard, overload and over weight. Spools and dies should be properly clamped. Do not allow the use of long shanks to increase the torque for tightening the dies. Mechanical shifting of spindle and cable mechanism and dies is not allowed. Clamping, adjustment, etc. should be performed after stopping. Protective devices are provided to ensure operator safety in case of abnormal equipment conditions. Disassembly of safety protection devices on the equipment is not allowed. Automatic winding machine is specially configured. Do not allow tools, workpieces and other debris to be placed directly in the diameter of wire screws and winding wires. Pay close attention to the operation. If you notice any abnormalities such as malfunction, vibration, heat, crawling, noise, odor and bruises, stop the machine immediately. After troubleshooting, you can continue working.

WhatsApp/Wechat：+86 13075286997

電子郵件: sales@vacuz.com [fusion_form form_post_id=”431″ margin_top=”” margin_right=”” margin_bottom=”” margin_left=”” hide_on_mobile=”small-visibility,medium-visibility,large-visibility” class=”” id=””][/fusion_form]